We use SRX's in pkt mode at some remote sites that don't need full blown
VPN/FW
security, mostly older SRX100s and SRX240s. We've recently installed a
SRX1500
at a larger site and everything works as expected, except none of the
VoIP phones
are getting their addresses from the dhcp relay. We have 6 VLANs on
site and all
of them get dhcp as expected, except the VoIP phones. Putting a laptop
on the
VoIP VLAN gets an IP correctly. Monitoring and mirroring the VLAN shows
the dhcp
reply packets being broadcast to the IRB, but the phones just stay in
the selecting
state in the binding table.
This is the first SRX running the JDHCP code levels so that's suspect,
but can't for
the life of me see why only the phones are having issues.
We were running the recommended 15.1X49-D150.2 and I upgraded this morning
to 15.1X49-D160.2 without any change.
Has anyone run into such an issue before?
thanks
mike
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
