I tried this and we got closer but it is replacing both inner and outer
tags now:
12:48:27.320821 00:22:07:4d:7b:0d > ff:ff:ff:ff:ff:ff, ethertype 802.1Q
(0x8100), length 350: vlan 424, p 0, ethertype 802.1Q, vlan 424, p 0,
ethertype IPv4, 0.0.0.0.68 > 255.255.255.255.67: BOOTP/DHCP, Request
from 00:22:07:4d:7b:0d, length 300
That should have been outer 424 inner 201.
The config:
baldur@formervangen-edge1# show interfaces xe-0/1/7
flexible-vlan-tagging;
native-vlan-id 424;
encapsulation flexible-ethernet-services;
unit 424 {
encapsulation vlan-vpls;
vlan-id 424;
input-vlan-map pop;
output-vlan-map push;
}
[edit]
baldur@formervangen-edge1# commit
commit complete
[edit]
baldur@formervangen-edge1# show routing-instances poi-formervangen |
display inheritance brief
protocols {
vpls {
## 'ethernet-vlan' was inherited from group 'POI-VPLS'
encapsulation-type ethernet-vlan;
## 'no-control-word' was inherited from group 'POI-VPLS'
no-control-word;
## 'mac-statistics' was inherited from group 'POI-VPLS'
mac-statistics;
mesh-group 1 {
vpls-id 424;
neighbor 10.9.124.0;
}
}
}
## 'vpls' was inherited from group 'POI-VPLS'
instance-type vpls;
interface xe-0/1/7.424;
Regards,
Baldur
On 20.05.2020 14.25, Mark Tees wrote:
You need to get rid of the vlan-id off the routing-instance.
End result I think should be similar to this:
Logical interface ge-1/0/6.888 (Index 650) (SNMP ifIndex 830)
Flags: Up SNMP-Traps 0x0 VLAN-Tag [ 0x8100.888 ] In(pop) Out(push
0x8100.888) Encapsulation: VLAN-VPLS
Yours is pushing 424 on ingress. Unless, you want to be matching on
both tags all you need is this:
set routing-instances VPLS instance-type vpls
set routing-instances VPLS interface ge-1/0/6.888
</snip>
set interfaces ge-1/0/6 unit 888 encapsulation vlan-vpls
set interfaces ge-1/0/6 unit 888 vlan-id 888
set interfaces ge-1/0/6 unit 888 input-vlan-map pop
set interfaces ge-1/0/6 unit 888 output-vlan-map push
You don't need to say anything about inner tags unless you are wanting
to do an operation on them? It sound like your remote side/ZTE does
the same as what I have mentioned above.
On Wed, 20 May 2020 at 22:13, Baldur Norddahl <[email protected]> wrote:
Hello
I am trying the suggestion received so far and now have this configuration:
baldur@formervangen-edge1# show interfaces xe-0/1/7
flexible-vlan-tagging;
native-vlan-id 424;
encapsulation flexible-ethernet-services;
unit 424 {
encapsulation vlan-vpls;
vlan-tags outer 424;
input-vlan-map {
push;
vlan-id 424;
}
output-vlan-map pop;
}
baldur@formervangen-edge1# show routing-instances poi-formervangen |
display inheritance brief
protocols {
vpls {
## 'ethernet-vlan' was inherited from group 'POI-VPLS'
encapsulation-type ethernet-vlan;
## 'no-control-word' was inherited from group 'POI-VPLS'
no-control-word;
## 'mac-statistics' was inherited from group 'POI-VPLS'
mac-statistics;
mesh-group 1 {
vpls-id 424;
neighbor 10.9.124.0;
}
}
}
## 'vpls' was inherited from group 'POI-VPLS'
instance-type vpls;
## 'inner-all' was inherited from group 'POI-VPLS'
vlan-id inner-all;
interface xe-0/1/7.424;
baldur@formervangen-edge1# run show interfaces xe-0/1/7
Physical interface: xe-0/1/7, Enabled, Physical link is Up
Interface index: 176, SNMP ifIndex: 541
Link-level type: Flexible-Ethernet, MTU: 1522, MRU: 1530, LAN-PHY
mode, Speed: 10Gbps, BPDU Error: None, Loop Detect PDU Error: None,
MAC-REWRITE Error: None, Loopback: None, Source filtering: Disabled,
Flow control: Enabled, Speed Configuration: Auto
Pad to minimum frame size: Disabled
Device flags : Present Running
Interface flags: SNMP-Traps Internal: 0x4000
CoS queues : 8 supported, 8 maximum usable queues
Schedulers : 0
Current address: e4:5d:37:8f:dc:7a, Hardware address: e4:5d:37:8f:dc:7a
Last flapped : 2020-05-20 11:14:05 CEST (02:54:05 ago)
Input rate : 0 bps (0 pps)
Output rate : 1384 bps (0 pps)
Active alarms : None
Active defects : None
PCS statistics Seconds
Bit errors 3
Errored blocks 3
Interface transmit statistics: Disabled
Logical interface xe-0/1/7.424 (Index 82) (SNMP ifIndex 607)
Flags: Up SNMP-Traps 0x4000 VLAN-Tag [ 0x8100.424 ] Native-vlan-id:
424 In(push .424) Out(pop) Encapsulation: VLAN-VPLS
Input packets : 14
Output packets: 66
Protocol vpls, MTU: 1522
Flags: Is-Primary
Logical interface xe-0/1/7.32767 (Index 111) (SNMP ifIndex 605)
Flags: Up SNMP-Traps 0x4004000 VLAN-Tag [ 0x0000.0 ] Encapsulation:
ENET2
Input packets : 426
Output packets: 456
Protocol multiservice, MTU: Unlimited
Flags: None
However the behaviour did not change. I am stilling receiving only
single tagged frames:
12:11:09.996863 00:22:07:4d:7b:0d > ff:ff:ff:ff:ff:ff, ethertype 802.1Q
(0x8100), length 346: vlan 201, p 0, ethertype IPv4, 0.0.0.0.68 >
255.255.255.255.67: BOOTP/DHCP, Request from 00:22:07:4d:7b:0d, length 300
It appears the vlan map is completely ignored.
Regards,
Baldur
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
