Hi.
I've created a 2.4.18p1+kbuild tree (clean 2.4.18p1 tree,
apply kbuild-2.5-2.4.16-3.bz2, kbuild-2.5-2.4.17-1.bz2,
kbuild-2.5-2.4.18-pre1-1.bz2) and copied in an old .config.
When I run 'make -f Makefile-2.5 oldconfig installable'
it loops in the oldconfig phase forever.
The tie-over of each iteration look like this:
*** End of Linux kernel configuration.
*** Check the top-level Makefile for additional configuration.
*** Next, you must run 'make dep'.
spec value %p not found
Using ARCH='i386' AS='as' LD='ld' CC='/usr/bin/kgcc' CPP='/usr/bin/kgcc -E' AR='ar'
HOSTAS='as' HOSTLD='gcc' HOSTCC='gcc' HOSTAR='ar'
Generating global Makefile
phase 1 (find all inputs)
#
# Using defaults found in .config
#
Any comments would be appreciated.
--
Regards,
Rasmus([EMAIL PROTECTED])
"Men kick friendship around like a football, but it doesn't seem to
crack. Women treat it like glass and it goes to pieces."
-- Anne Spencer Morrow Lindbergh
_______________________________________________
kbuild-devel mailing list
[EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/kbuild-devel
