Sorry, previous one was bionic. This is cosmic:
ubuntu@d06-2:~$ cat /proc/version
Linux version 4.18.0-17-generic (buildd@bos02-arm64-075) (gcc version 7.3.0 
(Ubuntu/Linaro 7.3.0-16ubuntu3)) #18~18.04.1-Ubuntu SMP Fri Mar 15 15:27:57 UTC 
ubuntu@d06-2:~$ sudo ethtool enp125s0f1
Settings for enp125s0f1:
        Supported ports: [ FIBRE ]
        Supported link modes:   25000baseSR/Full 
        Supported pause frame use: Symmetric
        Supports auto-negotiation: No
        Supported FEC modes: Not reported
        Advertised link modes:  Not reported
        Advertised pause frame use: No
        Advertised auto-negotiation: No
        Advertised FEC modes: Not reported
        Speed: 10000Mb/s
        Duplex: Full
        Port: FIBRE
        PHYAD: 0
        Transceiver: internal
        Auto-negotiation: off
        Link detected: yes

** Tags removed: verification-needed-bionic
** Tags added: verification-done-bionic

You received this bug notification because you are a member of Kernel
Packages, which is subscribed to linux in Ubuntu.

  hns3 nic speed may not match optical port speed

Status in linux package in Ubuntu:
  Fix Released
Status in linux source package in Bionic:
  Fix Committed
Status in linux source package in Cosmic:
  Fix Committed
Status in linux source package in Disco:
  Fix Released

Bug description:
  The onboard optical NICs on HiSilicon D06 systems do not adjust to match the 
actual optical module speed.

  [Test Case]
  Verify that linked speed of interface matches the optical port speed.

  5d497936756fa net: hns3: Config NIC port speed same as that of optical module

  [Regression Risk]
  Fix is restricted to a driver that is only used for the Hi1620 SoC. Note: for 
pre-GA hardware, this does require a firmware fix as well. Without it, users 
will see messages like this on the console:

  [ 769.833818] hns3 0000:bd:00.0: get sfp speed failed -5

To manage notifications about this bug go to:

Mailing list:
Post to     :
Unsubscribe :
More help   :

Reply via email to