>>>>> Hi,
>>>>>
>>>>> I work on a driver (drivers/net/ethernet/mellanox/mlxsw) that is made up
>>>>> of three modules: mlxsw_pci, mlxsw_core and a third module that is
>>>>> loaded by mlxsw_core according to the probed PCI device ID via
>>>>> request_module(). However, this function fails with rawhide kernels
>>>>> during boot.
>>>>>
>>>>> While debugging this, I found out that if I build the kernel myself with
>>>>> the exact same config, but set CONFIG_MODULE_SIG=n, then everything is
>>>>> fine. In addition, when modprobing mlxsw_pci myself all the modules are
>>>>> successfully loaded.
>>>>>
>>>>> Any ideas how this can be solved? Did anyone else bump into this
>>>>> problem?
>>>>>
>>>>> Thanks.
>>>>>
>>>>
>>>>Can you share kernel logs showing the error?
>>>
>>>The only error in the log is the one from the driver:
>>>
>>>mlxsw_pci 0000:03:00.0: cannot register bus device
>>>mlxsw_pci: probe of 0000:03:00.0 failed with error -22
>>
>> Laura, note that this is because module mlxsw_spectrum failed to load in
>> this function:
>>
>> static struct mlxsw_driver *mlxsw_core_driver_get(const char *kind)
>> {
>> struct mlxsw_driver *mlxsw_driver;
>>
>> spin_lock(&mlxsw_core_driver_list_lock);
>> mlxsw_driver = __driver_find(kind);
>> if (!mlxsw_driver) {
>> spin_unlock(&mlxsw_core_driver_list_lock);
>> request_module(MLXSW_MODULE_ALIAS_PREFIX "%s", kind);
>> spin_lock(&mlxsw_core_driver_list_lock);
>> mlxsw_driver = __driver_find(kind);
>> }
>> if (mlxsw_driver) {
>> if (!try_module_get(mlxsw_driver->owner))
>> mlxsw_driver = NULL;
>> }
>>
>> spin_unlock(&mlxsw_core_driver_list_lock);
>> return mlxsw_driver;
>> }
>>
>> Here, "request_module" won't load the mlxsw_spectrum module. But this issue
>> happens only during the boot time.
>>
>> If you try to "modprobe mlxsw_pci" by hand later on, all works fine.
>
> Is mlxsw_pci actually in the initramfs, and is it signed in it?
I was about to ask the same. for the generic initrd dracut matches
modules against a particular setup call/funciton [1] for a class of
devices to work out what to pull in and often these sort of modules
don't match as the sub modules. I have a similar issue with the
dw_mmc-* where the core dw_mmc.ko gets pulled in but not the HW
specific variants. I'm not worked out a good clean way to deal with
that in dracut as yet.
Peter
[1] storage uses these
'ahci_platform_get_resources|ata_scsi_ioctl|scsi_add_host|blk_cleanup_queue|register_mtd_blktrans|scsi_esp_register|register_virtio_device|usb_stor_disconnect|mmc_add_host|sdhci_add_host|scsi_add_host_with_dma'
_______________________________________________
kernel mailing list
[email protected]
https://lists.fedoraproject.org/admin/lists/[email protected]
