Hi,
If you want to see the SCSI mid-layer implementation check out:
drivers/scsi/scsi.c
If you are curious about the SCSI commands sent to a SCSI disk you can
look at:
drivers/scsi/sd.c
SCSI tape:
drivers/scsi/st.c
SCSI optical media (CDs/DVDs)
drivers/scsi/sr.c
SCSI enclosures
drivers/scsi/ses.c
For the embedded email from Vichy:
6,10,12 and even 16 is the (CDB) command length.
In the case of Write CDB size allows you to adjust the LBA, Transfer
Length, etc. Some older targets do not handle larger CDB sizes.
http://en.wikipedia.org/wiki/SCSI_CDB
http://en.wikipedia.org/wiki/SCSI_Write_Commands
Enjoy!
-- Mark
On Mar 24, 2009, at 4:21 AM, Sandeep K Sinha wrote:
On Tue, Mar 24, 2009 at 1:27 PM, loody <[email protected]> wrote:
Hi:
2008/3/15 vichy <[email protected]>:
Dear all:
I found there is number at the end of SCSI commands like below:
Command document
WRITE(6) SBC
WRITE(10) SBC
WRITE(12) SBC
Could someone tell me what the number, (6), (10) and (12) mean?
Appreciate your help,
vichy
--
To unsubscribe from this list: send an email with
"unsubscribe kernelnewbies" to [email protected]
Please read the FAQ at http://kernelnewbies.org/FAQ
Does anyone where the implementation about SCSI commands in linux
driver?
I want to compare the source with the spec.
Look into scsi_ioctl( ).
Its located in linux/drivers/scsi/scsi_ioctl.c
HTH,
Sincerely Yours,
miloody
--
To unsubscribe from this list: send an email with
"unsubscribe kernelnewbies" to [email protected]
Please read the FAQ at http://kernelnewbies.org/FAQ
--
Regards,
Sandeep.
“To learn is to change. Education is a process that changes the
learner.”
--
To unsubscribe from this list: send an email with
"unsubscribe kernelnewbies" to [email protected]
Please read the FAQ at http://kernelnewbies.org/FAQ
--
To unsubscribe from this list: send an email with
"unsubscribe kernelnewbies" to [email protected]
Please read the FAQ at http://kernelnewbies.org/FAQ
