From: Daniel Thompson <daniel.thomp...@linaro.org>
Support kgdb NMI console feature via implementing poll_get_irq()
interface. This will allow usage of RX interrupts to support kgdb entry
while serial device is operating in polling mode.
Signed-off-by: Daniel Thompson <daniel.thomp...@linaro.org>
Signed-off-by: Sumit Garg <sumit.g...@linaro.org>
---
drivers/tty/serial/8250/8250_port.c | 16 ++++++++++++++++
1 file changed, 16 insertions(+)
diff --git a/drivers/tty/serial/8250/8250_port.c
b/drivers/tty/serial/8250/8250_port.c
index f77bf82..1473b1a 100644
--- a/drivers/tty/serial/8250/8250_port.c
+++ b/drivers/tty/serial/8250/8250_port.c
@@ -2138,6 +2138,21 @@ static void serial8250_put_poll_char(struct uart_port
*port,
serial8250_rpm_put(up);
}
+static int serial8250_get_poll_irq(struct uart_port *port)
+{
+ unsigned int ier;
+ struct uart_8250_port *up = up_to_u8250p(port);
+
+ serial8250_rpm_get(up);
+
+ ier = serial_port_in(port, UART_IER);
+ ier |= UART_IER_RLSI | UART_IER_RDI;
+ serial_port_out(port, UART_IER, ier);
+
+ serial8250_rpm_put(up);
+ return port->irq;
+}
+
#endif /* CONFIG_CONSOLE_POLL */
int serial8250_do_startup(struct uart_port *port)
@@ -3141,6 +3156,7 @@ static const struct uart_ops serial8250_pops = {
#ifdef CONFIG_CONSOLE_POLL
.poll_get_char = serial8250_get_poll_char,
.poll_put_char = serial8250_put_poll_char,
+ .poll_get_irq = serial8250_get_poll_irq,
#endif
};
--
2.7.4
_______________________________________________
Kgdb-bugreport mailing list
Kgdb-bugreport@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/kgdb-bugreport
