On 4/18/2012 3:48 PM, jean-pierre charras wrote:
Le 18/04/2012 20:25, Dick Hollenbeck a écrit :
I am working on this today.
My gut says this:
Basically it comes down to the fact that we cannot describe an area
larger than about 12
feet with the nanometer internal units.
Jean-Pierre,
Can you first look over the attached patch, then play with it.
This basically fixes the crash, but I think there's more finishing
touches that need to be
done.
I need to get back to work now.
Thank you very much,
Dick
I'll work on that tomorrow.
I also make some tests.
Under Windows I did now have crashes, but I had other issues.
Make sure you're not getting bit by this bug
http://trac.wxwidgets.org/ticket/10446 again. I don't know if this
problem has ever been fixed or even if it still exists on Window's Vista
and/or 7.
my opinion is with 32 bits integers we cannot handle more than something
like 50 to 70 cm,
with nanometers units.
I noticed there are a lot of issues when calculating distance between 2
points.
Assuming calculations are using integers, with 32 bits we can handle 2
meters distances only.
if Xmax and Ymax are Y and Y difference between 2 points,
only Y or Y max <= 1.4 meter, if sqrt( Xmax*Xmax + Ymax*Ymax) always < 2m.
Because a distance is always >= 0, this means X and Y coordinates must
have absolute coordinates < 70 cm.
With margins around work area, and because Pcbnew and Gerbview use a
page only with positive coordinates,
the active area has a size < 50cm, roughly 20 inches, or A3 or B page size.
_______________________________________________
Mailing list: https://launchpad.net/~kicad-developers
Post to : [email protected]
Unsubscribe : https://launchpad.net/~kicad-developers
More help : https://help.launchpad.net/ListHelp
