On 07/03/2012 05:09 AM, Carl Rash wrote: > Dick, > The diameter of the hole and the diameter of the via pad are correct > (verified with 3rd party gerber viewer), 0.015 and 0.025. The problem is the > hole is off center. I believe this code in gendrill.cpp is selecting the > size of the drill and that is correct. It may be that placing a hole within > one half a mil is not possible using the NC format if that is the case then > I would have like to have it detected at the DRC phase and not after > submission to the PCB fabrication house. Perhaps a minimum annular ring test > would be a good DRC check. > I am going to try and change the next grid hot key to a combination like > Ctrl+G that way It will not be likely that I can inadvertently change grid > size without knowing it. I have never used auto routers, I prefer to do it > myself so I depend on the grid staying where I set it. > > Thanks for time > Carl Rash
Is there actually a bug here? It is sounding like a user error, not a true bug. It is fully understandable that you do not like the current functionality, which might be validly classified as something other than a bug. _______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : [email protected] Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp
