On 10/14/2013 12:12 PM, jp charras wrote: > Le 14/10/2013 17:27, Wayne Stambaugh a écrit : >> I was fixing the Pcbnew block rotate hot key when I discovered that the >> block rotate command in both Pcbnew and Eeschema (and I'm assuming the >> component and footprint library editors as well) do not behave the way I >> thought they did or should. When a block is selected and either the >> rotate hot key or context menu is selected, the block rotates at the >> original selection point and the block command ends. Shouldn't the >> block command continue until the user presses the left mouse key to >> actually place the rotated block? This makes more sense to me and would >> allow you to perform more than one rotation during the block command. >> If no one objects, I'll add it to my list. >> >> Wayne >> > > No objection. > Just it makes preparing the Undo/Redo command slightly more difficult to > code. > > Pcbnew rotate has a potential bug relative to the Undo command: in > preferences the rotation can be adjusted to 45 or 90 degrees. > for 90 degrees, no problems. > But for 45 degrees, the undo does not work, because the undo rotate code > assumes a 90 degrees rotation (the actual rotation angle is not stored). > > How do you rotate a block 45° in Pcbnew? The only command paths I see are the block context menu rotate command and the rotate hot key both of which rotate the block 90° clockwise.
_______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : [email protected] Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp
