I also agree that grid 100 (logical units or mils) should be added to
Eeschema.
As most of symbols have pins created using grid 100 (2x50), it is
reasonable to use grid 100 when drawing wires on schematic.
It will help to avoid unconnected pin and wire especially when grid dot
are not visible (zoomed out).
BTW, I think there should be possibility to use user defined grid size
in Eeschema instead of predefined few grid sizes. It would solve the
problem.
Mariusz
W dniu 2014-04-22 18:58, Vesa Solonen pisze:
22/04/14 19:54, Lorenzo Marcantonio kirjoitti:
I don't see a problem, just draw the ISO symbols large as 'two' kicad
units per module. Or the 50 mils size is something more magic than
simply the currently biggest grid in eeschema?
Just pointing out that for consistency all pins (and border) must fit on
100 mils grid without any (multiple of) 50 mils offset. 50 mils is
reserved for symbols internal use. Oh, it would be fine to add 100 mils
grid to Eeschema too.
-Vesa
_______________________________________________
Mailing list: https://launchpad.net/~kicad-developers
Post to : [email protected]
Unsubscribe : https://launchpad.net/~kicad-developers
More help : https://help.launchpad.net/ListHelp
---
Ta wiadomość e-mail jest wolna od wirusów i złośliwego oprogramowania, ponieważ
ochrona avast! Antivirus jest aktywna.
http://www.avast.com
_______________________________________________
Mailing list: https://launchpad.net/~kicad-developers
Post to : [email protected]
Unsubscribe : https://launchpad.net/~kicad-developers
More help : https://help.launchpad.net/ListHelp
