Pads 50 are there only to paste stencil format. But both Bottom and Top pad are number 49 that in schecmatic is connected to GND.
2014-12-12 13:36 GMT+00:00 LordBlick <[email protected]>: > In response to a message written on 12.12.2014, 14:32, from LordBlick: > >> In response to a message written on 12.12.2014, 13:36, from José Eduardo >> S. C. >> Xavier: >> >>> Hi, >>> >>> DRC check is saying that the a PAD isn't connect but it is connected. >>> You can >>> see in the video what is happening: >>> https://www.dropbox.com/s/g9582x45psmjtid/error_drc.ogg?dl=0 >>> >>> The project board: https://www.dropbox.com/s/ >>> j5wd9xzpvcrytix/pcb.zip?dl=0 >>> >>> To solve that DRC error I need to remove the bottom pad 49 on the IC1 >>> that was >>> first add to make the bottom to look better, without that it looks >>> something >>> like that: http://i.imgur.com/erqkX3x.png. >>> >>> >>> What is causing that DRC error? >>> >>> PS: I than realize that I didn't need that pad and only need to change >>> the pad >>> connection on each hole to solid to make it look good. >>> >> Its bad idea that some SMD componens have some elements on Bottom layer. >> > Independly, pads „50” have not defined any net connection > > > -- > Best Regards, > LordBlick > > _______________________________________________ > Mailing list: https://launchpad.net/~kicad-developers > Post to : [email protected] > Unsubscribe : https://launchpad.net/~kicad-developers > More help : https://help.launchpad.net/ListHelp >
_______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : [email protected] Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp
