Can you provide the project, such i can try it? Den 30/12/2014 17.59 skrev "Andy Peters" <[email protected]>:
> > > On Dec 30, 2014, at 9:51 AM, Nick Østergaard <[email protected]> wrote: > > > > Have you tried connectong the nets? To me it do indeed look like you > have two nets seperated, hence it is un connected. > > Yes, they're connected. What's not shown in the screen shot is that the > +15V net comes in from the right, where the two horizontal +15V traces meet > a vertical trace, which goes down to the regulator. > > Believe me, I've drawn and re-drawn this thing like two dozen times! > > > -a > > > > > > Den 30/12/2014 17.43 skrev "Andy Peters" <[email protected]>: > > I'm using my build of BZR 5337 on OS X 10.10.1 (same problem on 10.9.5). > > > > I have a completely routed design, not all that complicated, and the DRC > is throwing an odd message: > > > > ErrType(2): Unconnected pads > > * @(4.7063 in,6.6754 in): Pad 8 on F.Cu, Non-copper of U6 net +15V > > * @(4.7112 in,5.6410 in): Pad 1 on B.Cu, Non-copper of C40 > > > > U6 is an IC; Pin 8 is its VCC pin that connects to the +15V net. C40 is > a decoupling cap that is hanging on the +15V net. But U6 is not near C40. > > > > I've attached a screen shot. It's hard to see, but the +15V trace does > connect to the capacitor and the IC pin. C40 is on the back of the board, > near the top center of the image. U6 is on the front of the board, sort of > middle, closer to the bottom edge of the image. > > > > "Non-copper" implies soldermask or perhaps silkscreen; why would that > even be an issue here? > > > > Thanks for ideas ... > > > > <kicad-no-connect.png> > > > > _______________________________________________ > > Mailing list: https://launchpad.net/~kicad-developers > > Post to : [email protected] > > Unsubscribe : https://launchpad.net/~kicad-developers > > More help : https://help.launchpad.net/ListHelp > > > > Andy Peters > 5511 E Rosewood St > Tucson, AZ 85711 > 520-907-2262 > [email protected] > > > > > _______________________________________________ > Mailing list: https://launchpad.net/~kicad-developers > Post to : [email protected] > Unsubscribe : https://launchpad.net/~kicad-developers > More help : https://help.launchpad.net/ListHelp >
_______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : [email protected] Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp
