Le 16/01/2015 03:19, LordBlick a écrit : > In response to a message written on 16.01.2015, 01:38, from LordBlick: >> I just discovered that for some reason Pcbnew does not display >> complete zones in >> just designed project. >> Looking into project file: >> (layers >> -> (0 Gorna jumper) >> -> (31 Dolna signal) >> (32 B.Adhes user) >> (33 F.Adhes user) >> (34 B.Paste user) >> (35 F.Paste user) >> (36 B.SilkS user) >> (37 F.SilkS user) >> (38 B.Mask user) >> (39 F.Mask user) >> (40 Dwgs.User user) >> (41 Cmts.User user) >> (44 Edge.Cuts user) >> ) >> And then in pycrust: >> >>> pcbnew.BOARD_GetStandardLayerName(0) >> u'F.Cu' >> >>> pcbnew.BOARD_GetStandardLayerName(31) >> u'B.Cu' >> What can I do with this mess in file ? >> Same name are in Areas/Zone, which is IMHO incorrectly. translations >> are good in >> user interface, not in project files… > Never mind, just test attachment. > BTW. I've found, that in GAL mode additional intermediate points between > area and subareas are displayed, which seems to be incorrect. See > attached image.
The pcb file has no issue, no mess. The Layers section is perfectly valid Copper layers can be renamed by the user. Your board is broken: Some zones are connected to nothing. For instance, the main zone has a net name = /GND, and many pads have a net name = GND which is not the same net. -- Jean-Pierre CHARRAS _______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : [email protected] Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp
