On 7/12/2015 3:51 PM, jp charras wrote: > Le 12/07/2015 21:12, Andrew Zonenberg a écrit : >> I pushed a patch to advanced-feature-bugfixes that hides the >> cursor when the mouse is outside the window. This only applies to >> GAL and does not change legacy. >> >> JP, can you be more specific about what would break in legacy if I >> were to do the same? >> >> > > When you are clicking on a component or a pin in schematic editor, the > graphic cursor of the board editor ( in legacy mode) is moved to the > footprint or the pad. > > When you are clicking on a footprint or a pad, the graphic cursor of > the schematic editor ( in legacy mode) is moved to the component or > the pin in schematic editor. > > if the graphic cursor is hidden, the cross probing shows nothing. >
Oops! Good catch JP. I forgot about that. The cross-probing should work the same way (at least as much as possible) in both canvases. I use this feature quite a bit on dual monitor setups. That being said, we should be able to clear the crosshair when leaving the canvas and redraw the crosshair when a crossprobing message is received unless another mouse leave message is sent after the crossprobe event occurs. I would expect that's not the case but occasionally there are some surprise messages that get sent by wxWidgets. _______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : [email protected] Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp
