Patch committed in product branch r6055. Thanks. On 8/5/2015 4:09 PM, Chris Pavlina wrote: > Fixed, patch attached. > > On Wed, Aug 05, 2015 at 06:46:43PM +0200, jp charras wrote: >> Le 05/08/2015 16:29, Wayne Stambaugh a écrit : >>> Patch committed in product branch r6053. Thanks. >>> >>> On 8/4/2015 5:32 PM, Chris Pavlina wrote: >>>> In any case, here's the patch to make undo configurable. I can edit it >>>> to change the default if you like. >> >> Thanks, Chris. >> >> I just tested this feature. >> It looks good but I noticed a minor and strange issue (only tested on >> Windows currently): >> >> the undo level value seems not (or incorrectly) read from config for the >> schematic editor only. >> After closing the schematic editor and re-run it, the undo level >> selection is always 0 (regardless the previous setting) if it is run >> from kicad manager >> However, if Eeschema is run in stand alone mode, after closing Eeschema >> and re-run it, the undo level selection is good (is is the last saved value) >> I am thinking this is a read config issue when eeschema is run from >> kicad manager. >> (Because if I run eeschema from kicad manager and set the undo stack to >> 3 and close kicad, if I run eeschema in stand alone, the undo stack is 3 >> (as expected), but if I run eeschema from kicad manager, the undo stack >> is 0) >> >> No problem for other editors. >> >> >> >> -- >> Jean-Pierre CHARRAS >> >> _______________________________________________ >> Mailing list: https://launchpad.net/~kicad-developers >> Post to : [email protected] >> Unsubscribe : https://launchpad.net/~kicad-developers >> More help : https://help.launchpad.net/ListHelp >> >> >> _______________________________________________ >> Mailing list: https://launchpad.net/~kicad-developers >> Post to : [email protected] >> Unsubscribe : https://launchpad.net/~kicad-developers >> More help : https://help.launchpad.net/ListHelp
_______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : [email protected] Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp
