I would like that very much, but not sure how feasible it is. Thoughts from someone who knows the DRC code?
On Sun, Jun 05, 2016 at 02:49:15PM -0700, Andrew Zonenberg wrote: > On that note... Thoughts on adding a new DRC rule for minimum annular ring? > > > On 05/06/16 14:29, Chris Pavlina wrote: > > Yeah, the vias still have their size stored in the pcb file. > > > > On Sun, Jun 05, 2016 at 09:27:08PM +0000, Jon Neal wrote: > >> Sounds like a fantastic idea. I've definitely been bitten by this one as > >> well. > >> > >> I am assuming this will still keep backwards compatibility for those who > >> have already created boards with default sized vias? > >> > >> On Sun, Jun 5, 2016 at 5:23 PM José Ignacio <[email protected]> wrote: > >> > >>> I like both suggestions, I got bitten by the annular ring issue before > >>> because the DRC doesn't even check for that. > >>> > >>> On Sun, Jun 5, 2016 at 4:06 PM, Chris Pavlina <[email protected]> > >>> wrote: > >>>> Hi, > >>>> > >>>> Just a quick warning - I'm going to update the default via size to 0.8mm > >>>> diam/0.4mm drill, as the current default of 0.6/0.4 isn't manufacturable > >>> at > >>>> most general purpose fabs. Annular ring too narrow. That should be > >>>> uncontroversial, but I'm still giving a bit of warning to make sure > >>> nobody's > >>>> too attached to that. > >>>> > >>>> Simon Wells suggested allowing that value to be read from the .pro > >>> instead, so > >>>> it can be set in the default template instead of hardcoded. I might do > >>> that > >>>> later, as it seems like a win in general. Objections? > >>>> > >>>> -- > >>>> Chris > >>>> > >>>> _______________________________________________ > >>>> Mailing list: https://launchpad.net/~kicad-developers > >>>> Post to : [email protected] > >>>> Unsubscribe : https://launchpad.net/~kicad-developers > >>>> More help : https://help.launchpad.net/ListHelp > >>> > >>> _______________________________________________ > >>> Mailing list: https://launchpad.net/~kicad-developers > >>> Post to : [email protected] > >>> Unsubscribe : https://launchpad.net/~kicad-developers > >>> More help : https://help.launchpad.net/ListHelp > >>> > > > > _______________________________________________ > > Mailing list: https://launchpad.net/~kicad-developers > > Post to : [email protected] > > Unsubscribe : https://launchpad.net/~kicad-developers > > More help : https://help.launchpad.net/ListHelp > > > _______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : [email protected] Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp
