It's on my list for today. It would be nice if an osx dev could test it before it's committed just in case there is some unexpected behavior on osx.
On 1/27/2017 7:43 AM, Chris Pavlina wrote: > Just tried this. It's REALLY nice to be able to nudge the model around > by turning the scroll wheel over the fields. <3 > > Anyone test this on something other than Linux yet? I'd like to see this > merged. > > On Thu, Jan 26, 2017 at 05:24:17PM +0100, Kristoffer Ödmark wrote: >> Yes, you can still manually change the values, I tried that. >> >> The only change I did to the code was to change the stepping of the offset >> to 0.1mm instead of 1 in this patch. the best thing is that you can now use >> the scrollwheel as well. Wich makes rotating stuff a breeze. >> >> - Kristoffer >> >> On 2017-01-26 17:09, Chris Pavlina wrote: >>> On Thu, Jan 26, 2017 at 09:49:40AM -0500, Wayne Stambaugh wrote: >>>> If no one is opposed to adding spin controls to the 3D model selection >>>> dialog, I'll commit this patch when I get a chance. I've never been >>>> convinced that using a spin control to change a floating point number is >>>> terribly useful but I'm guessing some users will prefer this over manual >>>> entry of calculated values used by old curmudgeons like me. >>> >>> I can see value in it. When you're moving around a 3D model, you don't >>> want to type in a specific value, you want to move it until it's >>> aligned. If the model is far off it can be hard to guess what the offset >>> should be like, so having a button to nudge it up and down could be nice. >>> >>> Might want to hold off for a bit though as I think there was talk about >>> an updated patch in IRC, this might not be final >>> >>>> >>>> On 1/26/2017 6:11 AM, Kristoffer Ödmark wrote: >>>>> Hello! >>>>> >>>>> One thing that has always bothered me is that when aligning 3D models to >>>>> fit the footprint, one have to type the value and test, delete >>>>> characters and test again. Very minor issue, but it still bothers me. >>>>> >>>>> With a spinbox the values can be changed using the mouse only. >>>>> >>>>> attaching the patch for this minor change. >>>>> >>>>> - Kristoffer >>>>> >>>>> >>>>> >>>>> _______________________________________________ >>>>> Mailing list: https://launchpad.net/~kicad-developers >>>>> Post to : [email protected] >>>>> Unsubscribe : https://launchpad.net/~kicad-developers >>>>> More help : https://help.launchpad.net/ListHelp >>>>> >>>> >>>> _______________________________________________ >>>> Mailing list: https://launchpad.net/~kicad-developers >>>> Post to : [email protected] >>>> Unsubscribe : https://launchpad.net/~kicad-developers >>>> More help : https://help.launchpad.net/ListHelp >>> >>> _______________________________________________ >>> Mailing list: https://launchpad.net/~kicad-developers >>> Post to : [email protected] >>> Unsubscribe : https://launchpad.net/~kicad-developers >>> More help : https://help.launchpad.net/ListHelp >>> > > > _______________________________________________ > Mailing list: https://launchpad.net/~kicad-developers > Post to : [email protected] > Unsubscribe : https://launchpad.net/~kicad-developers > More help : https://help.launchpad.net/ListHelp > _______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : [email protected] Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp
