Hi JC, On 06/22/2018 12:22 AM, jc wrote: > I would like to explode an intersect, like 2 lines,if crossed, turn into 4.
We need more information. What intersecting lines are you talking about? Wires in the schematic editor or traces, zones, or polygons in the board editor? Also, why do you want to split intersected lines? This would make it easier for someone to point you in the right direction. > > > This can be done easily with a line of command in autocad, 30yrs ago. I am old enough to have used autocad 30 years ago and I can say with absolute certainty that trying to layout a board with autocad now or then is folly. Comparing a 2D drawing program with a board layout program is not helpful. > > I want to mske that happen in 4.0.7. Where should i start? The version 4 branch is a dead branch. There will be no further development in this branch. You are also too late for version 5 which is going to be release very soon. You should use the development branch of KiCad at https://code.launchpad.net/~kicad-product-committers/kicad/+git/product-git/+ref/master > > > > > > _______________________________________________ > Mailing list: https://launchpad.net/~kicad-developers > Post to : [email protected] > Unsubscribe : https://launchpad.net/~kicad-developers > More help : https://help.launchpad.net/ListHelp > _______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : [email protected] Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp
