On 1/11/19 1:51 PM, Steven A. Falco wrote:
> On 1/11/19 1:21 PM, Seth Hillbrand wrote:
>> Am 2019-01-11 12:18, schrieb Steven A. Falco:
>>> I tried another ngspice experiment. I ran a simulation, and it
>>> worked, albeit with the data size warning I asked about earlier. So
>>> far so good.
>>
>> That warning was saying that it ran out of memory and had overwritten
>> unplanned space. I would expect a crash after that. I'm not sure that
>> KiCad can trap that kind of error as it occurred inside the library.
>
> Ok, but I'm concerned about the bug reports I'll get if I were to enable
> ngspice and push the build to the Fedora community.
>
> I'll wait to see if the forum has any thoughts on the warning. I'll only
> enable ngspice in the official Fedora builds if I can get to where the
> examples run cleanly.
I saved the netlist from the simple example I've been running:
.title KiCad schematic
V101 in 0 PULSE (0 5 1u 1u 1u 1 1)
C101 Net-_C101-Pad1_ 0 1u
C102 out 0 100n
R101 Net-_C101-Pad1_ in 10k
R102 out Net-_C101-Pad1_ 1k
.save @v101[i]
.save @c101[i]
.save @c102[i]
.save @r101[i]
.save @r102[i]
.save V(0)
.save V(GND)
.save V(Net-_C101-Pad1_)
.save V(in)
.save V(out)
.tran 1u 100m
.end
When I run this circuit in stand-alone ngspice, it does a lot of overprinting,
apparently to indicate the run-time of the job. Here is a small example of the
character stream, where there are tons of backspaces as part of the
overprinting:
saf$ od -c foo
0000000 % 0 . 0 0 \b \b \b \b \b % 0 . 0 0 \b
0000020 \b \b \b \b % 0 . 0 0 \b \b \b \b \b % 0
0000040 . 0 0 \b \b \b \n
0000047
The stand-alone captured output from this simple circuit is around 1 Mbyte!
I'm guessing that this huge amount of data is blowing up the window and showing
all of the strange characters.
I'm not sure of the division of labor here. Is that something that a KiCad
developer should address, or is it a library issue? Hopefully there is a flag
that can be passed to the library to suppress the overprinted text.
Steve
_______________________________________________
Mailing list: https://launchpad.net/~kicad-developers
Post to : [email protected]
Unsubscribe : https://launchpad.net/~kicad-developers
More help : https://help.launchpad.net/ListHelp
