Wire, bus, graphic line, and sheet but only when enabled with an immediate hotkey. When I enable the tool via a toolbar button or selecting a menu entry, then the behavior is the same as the legacy tool framework. It really should not matter how a tool is enabled, only the initial behavior.
On 6/18/2019 7:53 AM, Jeff Young wrote: > Hi Wayne, > > I wrote the whole PushTool/PopTool stuff exactly for that case. Which action > in particular is going back to the SelectionTool? > > (Note that some are “supposed” to. If you click on a tool in the toolbar, or > select it from the Place menu, then cancelling should take you back to the > SelectionTool. However, if you use the context menu or a hotkey, it should > push and then pop the drawing tool. Not to say that it’s not buggy, or that > the design behaviour isn’t optimal.) > > Cheers, > Jeff. > > PS: should I make the same changes to Pcbnew, or should be await more > feedback? (Feedback on the forums has been uniformly positive so far, but > pretty sparse with only 3 likes.) > > >> On 18 Jun 2019, at 12:48, Wayne Stambaugh <[email protected]> wrote: >> >> Hey Jeff, >> >> I spent some time this morning playing around with the "immediate" >> hotkeys in Eeschema and it's better but there is still one annoying >> difference from the legacy behavior. When cancelling (escape key) a >> drawing in progress, the drawing is aborted, the current tool is >> canceled, and the selection tool is enable. The legacy behavior was >> abort the drawing in progress and keep the current tool enabled. The >> current tool would only be canceled when it was not busy drawing >> something. It's rather cumbersome to have to keep enabling the drawing >> tool every time you exit a drawing when you make a mistake. >> >> Cheers, >> >> Wayne >> >> On 6/15/2019 3:45 PM, Jeff Young wrote: >>> I’ve checked in code which makes the drawing hotkeys “immediate” in >>> Eeschema and the Symbol Editor. It was more involved than I was expecting, >>> so there may be some nasty surprises. >>> >>> I folks like it, I can apply the same architecture to Pcbnew. >>> >>> Cheers, >>> Jeff. >>> _______________________________________________ >>> Mailing list: https://launchpad.net/~kicad-developers >>> Post to : [email protected] >>> Unsubscribe : https://launchpad.net/~kicad-developers >>> More help : https://help.launchpad.net/ListHelp >>> >> >> _______________________________________________ >> Mailing list: https://launchpad.net/~kicad-developers >> Post to : [email protected] >> Unsubscribe : https://launchpad.net/~kicad-developers >> More help : https://help.launchpad.net/ListHelp > _______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : [email protected] Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp
