Hi,
I'm new to KiCad and I'd need some advice. What is the best way to lay out 40 differential pairs? Estimated line width is 5 mils, with 7 mils spacing, and 23 mils between pairs. Most of ICs are metric, but pairs originate from a 240-pin (8 x 30) BGA connector using 50 mils pitch. An 8-layer board is planned: 3 ground planes, 1 power plane, 2 stripline layers and 2 microstrip layers. Can I rely on PcbNew's manual routing capabilities, or I'd better look for something else? I cannot afford any of the "high end" packages. And I don't think I'd like their complexity either :-) Regards, Sinisa
