I often use PCB-Pool. With target I just sent them the board file but in order to send them the board I have made with KiCad I must send a packet of gerber files assembled with GC-Prevue, and I have been looking up the technical requirements. I noticed this technical note:
http://www.pcbpool.com/download/spezifikation/eng_stopplack_vias_englisch.pdf Ehich is basicaly saying I must either fully expose or fully cover vias. As they use foil plating I would prefer my vias fully covered with solder mask, but then I realised I could not find anywhere to specify the solder mask clearence. How is this specified, and is there any way to get my vias fully covered? BTW, has anybosy experience with sending KiCAD files to PCB-Pool? Thanks in advance, Roger.
