Great idea. I'll use it if I'll have the same troubles.
Boštjan
On Feb 12, 2007, at 9:02 AM, arnaud.lemeur wrote:
GND was connected to OpenEm pin of a transistor, when I tried to
connect PWR_FLAG, ERC detected a input power in the OpenEm of the
transistor. I've just put a 0 Ohms resistor between transistor pin and
GND.
--- In [email protected], Boštjan Jerko <[EMAIL PROTECTED]> wrote:
>
> Did you also connect GND of the component (with pin 1 as power_in)
> to a power component GND?
>
> Boštjan
>
> On 2007.2.9, at 15:46, arnaud.lemeur wrote:
>
> > Hi,
> >
> > When I connect GND to PWR_FLAG, ERC returns an error ("Pin
power_out
> > connected to a Pin openEm"). But GND pin 1 is power_in when I
verify
> > by editing component.
> >
> > What can I do to solve this problem ?
> >
> > Thanks,
> >
> >
> >
>
> ---
> mag./M.Sc. Boštjan Jerko
> Boštjan Jerko-Japina s.p., Raziskovanje in razvoj novih tehnologij
> Boštjan Jerko-Japina s.p., Research and development of new
technologies
>
> *******************
> Elektronika/Electronics,
> Software/Programi: http://www.japina.eu
> slo. blog: http://www.japina.eu/blog-slo
> Eng. blog: http://www.japina.eu/blog-eng
> trgovina/store: http://www.japina.eu/store
>
