--- In [email protected], Dave - WB6DHW <brain...@...> wrote:
>
> ghf082 wrote:
> > Hello All: I do not want to use the schematic part of KiCad but
> > layout a pc board manually....that is selecting pads, placing them,
> > selecting track width, etc., placing them, etc, Can I do that with
> > Kicad? I am able to route tracks manually but do not seem to be able
> > to place pads where I want them. Any help will be most appreciated.
> > Regards, George
> >
> >
Thanks Dave, ...I am not sure how to do that, but will experiment. 73
W3ase George
> > You need to place modules rather than individual pads. You
could use the module editor to create a module that consists of a
single pad.
> >
> Dave - WB6DHW
> <http://wb6dhw.com>
>
