AD5VJ Bob wrote: > I have designed a circuit and have found a supplier for who has all of the > parts I need and the data sheets, ect.. > > The problem I am having is that I am wanting to put a circuit board mount > type 3.55mm audio plug on the drawing for the pcb > manufacturer to have the holes there that I need to install it once I get the > board back. > > I have gone to their site and found the audio plug that I want to use, but > there are no mechanical measurements for it on the > website. > > Are these connectors so common in their sizes that it is not necessary to > specify the holes by using a footprint from the libraries, > or do you just put pads on the board where you want it installed? > > Bob AD5VJ > > > > > They are definately not all the same physical layout on the holes. If they don't have a drawing, then order one and measure it and make your own module. The dtereo jacks I use on the UHFSDR board are from All Electronics CAT # MJW-12. I made a module for them.
Dave - WB6DHW <http://wb6dhw.com>
