--- In [email protected], Andy Eskelson <andyya...@...> wrote: > > Make sure you run DRC on the circuit diagram before you run cvpcb > That will highlight any errors there. > > I would think that it is very likely that the libs you exported are not > correct for what you want to do. > > In Kicad, there are libs and mods. The lib is basically the schematic > drawing of the device, and the module is the physical drawing of the > device. The important bit is that both the lib and mod must agree on > names such as pin numbers and such like. In addition to this the pins in > the lib have to be defined as a particular type. (power in, power out, > bidi, ...) > > Libs and Mods are almost a set pair, the exception being where one > footprint applies to a range of devices, i.e. a 7805, 7809, 7812 etc. > regulator all use the same footprint module. For things like micros, it's > normally one lib to one module. > > > Run through the tutorial a couple of times, it takes a bit of practise > at first, especially the part regarding creating your own parts. > > Also Try to use the Kicad libs and modules at first, once you get used > to it then try the other libs (if you need them) and check them before > use. > > Andy > > > On Wed, 01 Apr 2009 11:37:46 -0000 > "joerglesniak" <joerglesn...@...> wrote: > > > High together, > > > > I'm new to kicad and started with a first schematic. Next step I used cvpcb > > to select the needed footprints of the parts (I exportet lib and mod from > > the Linux Eagle 5 -Version libraries needed). When opening the board, I see > > that maybe 20% of the airwires are missing!? > > > > I'm quite confused where to start to find out what I made wrong. The DRC > > just gives me errors for unconnected device-pins (I really don't neede > > these pins). I think there could be something wrong with the > > lbr/mod-files!? But what? > > > > Could please anyone help me out? I'm stuck > > > > Thanks a lot and regards > > > > Nukem36 > > > > > > > > ------------------------------------ > > > > Please read the Kicad FAQ in the group files section before posting your > > question. > > Please post your bug reports here. They will be picked up by the creator of > > Kicad. > > Please visit http://www.kicadlib.org for details of how to contribute your > > symbols/modules to the kicad library. > > For building Kicad from source and other development questions visit the > > kicad-devel group at http://groups.yahoo.com/group/kicad-develYahoo! Groups > > Links > > > > > > > High Andy!
thanks for your reply. I'm working now on the ERC error list. As far as I see the pads do have different names in the library element and the footprint. I'll try to fix that to be able to use the eagle libs Thanks for your support Regards Nukem36
