ok I understood. sorry if it was obvious.
I just finished all my PCB. I'll order asap on BatchPCB, even if I'm in europe and they are in US. I guess there are many cheaper, but I had difficulties to find them... thanks a lot !!! --- In [email protected], "axtz4" <ax...@...> wrote: > > --- In [email protected], Julien Bayle <julien.bayle@> wrote: > > > > hi, > > > > I create a pretty ground zone in order to suppress some tracks. > > no problem for the zone creation. it is very well documented so.. > > > > BUT I have a little problem: > > after the filling of the zone, it remains all the tracks existing between > > the pads supposed to be connected to the zone. > > > > I put a snapshot of this. > > > > Could someone help me ? > > With the latest rev, you don't need to create tracks between pads that will > be connected to the zone; thermal reliefs will be automatically created, with > the relief widths of the size specified in the zone fill dialog. > > Two exceptions to this. You may want "normal" reliefs to be wider than will > fit into a small pad, like a TQFP. In that case, use a narrow trace and > connect that pad to another component on the net as usual. The other > exception would be power pads where you might want much larger traces. Again, > draw these separately at the desired width. > > Once you fill the zone, any existing traces will be merged to the zone in the > Gerber file and won't be separately visible in the final board. >
