OK, this thing is about to make me pull my hair out! I am trying my best to lay out a surface mount board and running into all kinds of problems.
1. It doesn't seem to want to route a VSS pad on an SMD to the underlying VSS plane on the layer next to it! 2. It doesn't even seem to recognize there even IS a relationship! 3. It routes traces right through the middle of an edge card connector. I thought maybe I set up the VSS layer (ZONE) incorrectly, so I placed a DIP right next to an SMD component and sure enough, it immediately placed a connection to the VSS layer right under the pad and then proceeded to route a line on the component layer to the VSS pin of the SMD chip next to it! What could I be doing wrong here? Thanks, Greg
