Hi, As suggested in an earlier post, the easiest way to place mounting holes on a module is:
1- place a throuh hole pad with the right drill size, 2- Uncheck the copper and component layers in the pad properties, At this point you will have a plated hole without pad on the copper and component layer. If you want an unplated hole you have to specify it to your board maker. That worked for me. Regards, --- In [email protected], "yeshe66" <yesh...@...> wrote: > > I have a RJ-11 connector that should be attached to the PCB with two 3.2 mm > plastic snaps. How do I create module with two holes which are not pads? If I > make the hole as a pad with zero copper size PCBNEW complains that "pad > (number) is missing" when I load the netlist. Is there a workaround? >
