I use the same version and I have a 4 layer board and I do zones on each layer just fine. I am sure you are doing something wrong, check you netlist and make sure you are filling a zone over a correct net. Martin
---- galaviel <[email protected]> wrote: > Hi, > > I'm trying to build a 2-layer board to be sent to BatchPCB.com. > > Yesterday I could swear that PCBNew let me do zone on both sides (copper, and > component). I used them for analog GND and VCC respectively. > > But today, after doing small netlist change, I cannot ! > > Whenever I try to add a 2nd zone, After I click the OK button on the > the "Fill Zone Options", the layer selection list box always > switches back to the copper layer. Then of course I get small pop-up > saying "DRC error: this start point is inside or too close an other area". > > I'm using Kicad 20090216-final on Win XP Pro. > > Am I getting something basic here? isn't the component side a copper > layer also? because I have some tracks routed there by the auto-router. > > Any help would be greatly appreciate as I really want to get this board > on the road :) > > TIA, Gal. > > >
