Thanks folks. I have DRC turned on but I had ratnesting (global) turned off. When I turned that on I could see the unconnected nets.
My past experience (long time ago now) was that it was possible to list in an ascii file, unconnected nodes from the PCB layout. I guess this does not exist in Kicad. Robbie --- In [email protected], Andy Eskelson <andyya...@...> wrote: > > This is the main function of the DRC. > > The DRC is available in both Eeschema and pcbnew. > The Eeschema DRC will tell you of unconnected components, and in pcbnew > it can tell you about unconnected pads and nets, and clearance problems. > > > Andy > > > On Wed, 30 Dec 2009 21:30:02 -0000 > "burnsrobbie" <burnsrob...@...> wrote: > > > I have only just started using Kicad and the first PCB is back from the > > prototype house. Good stuff indeed. > > > > As is usual, there were a few errors on the PCB; this time 2 unrouted nets > > that I missed. Not a disaster but irritating all the same. > > > > Is there a function or report out of the PCB program that would show > > unconnected nets (that the schematic would say should be connected). > > > > I've looked but not found a function for this so apologies if this is an > > obvious one. > > > > Thanks in advance > > Robbie > > > > > > > > ------------------------------------ > > > > Please read the Kicad FAQ in the group files section before posting your > > question. > > Please post your bug reports here. They will be picked up by the creator of > > Kicad. > > Please visit http://www.kicadlib.org for details of how to contribute your > > symbols/modules to the kicad library. > > For building Kicad from source and other development questions visit the > > kicad-devel group at http://groups.yahoo.com/group/kicad-develYahoo! Groups > > Links > > > > > > >
