You have a problem with clearance at the location stated. Pads and tracks are set with a specified clearance zone, so if a track or pad enters such a zone this generates an error. You need to look at the problem area then decide what the clearance should be, or perhaps route the track differently (sometimes a turn in the track direction can just clip the edge of a pads clearance zone)
As you have made the footprints yourself, you may have been a bit over generious with clearance at that stage. Unfortunatlly there is not a specific answer, you just have to look at the board to decide what is going on. Andy On Mon, 25 Jan 2010 04:58:42 -0000 "tommak123abc" <[email protected]> wrote: > I've made some footprints of a 32 pin package, but when trying to connect a > track to the pin I get an error such as > > "EnType(4) - Track Near Pad" @(3.7126",5.1831") Track 0.0120" [ N-0001] on > Component Net:19 Length .0650" > @ (3.7126",5.2028") Pad 2 (Component) of U9 > > and it doesn't let me complete the routing of the track. > > What am I doing wrong, and what do I need to do to fix it? > > Any help would greatly be appreciated! Tom > > > > ------------------------------------ > > Please read the Kicad FAQ in the group files section before posting your > question. > Please post your bug reports here. They will be picked up by the creator of > Kicad. > Please visit http://www.kicadlib.org for details of how to contribute your > symbols/modules to the kicad library. > For building Kicad from source and other development questions visit the > kicad-devel group at http://groups.yahoo.com/group/kicad-develYahoo! Groups > Links > > >
