You probably had increased the counts before you setup the pitch. I made the same mistake before. You can re-do it or edit it with the module editor to correct the problem. Regards, Bill
--- In [email protected], "josh_eeg" <josh...@...> wrote: > > I am trying to use footprint builder to make the the ads1298 foot print from > the data sheet > it says all units are in mm p72 of the data sheet. > > near the corners of the footprint output the pins cross I am not shure what I > am doing wrong I am using the larger mm units on the data sheet so it is > larger & the coma as a period. >
