Dan, i remember going through this exercise about 13 years ago. I did find some tension numbers that seemed to apply to the cables on a KR. I bought a tensionometer and proceeded to set everything up. The numbers are way to much. I ended up doing it by feel and also tried getting a reading from the gauge after adjusting everthing and it did not even register on the meter. I have never had to adjust the cables since original set up and there is still no sloop in the system. My advice is to adjust to a no sag and no sloop in the movement. I adjusted until I had instant response (movement) from either the elevator, rudder , or alirons. As a side note to this I had installed the Dynon AP a few years ago. The slight drag on the servos dampened the sensitivity but has no impact on the responsiveness. Joe Horton Coopersburg, PA.
----- Original Message ----- From: "Dan via KRnet" <krnet at list.krnet.org> Subject: KR> Cable Tension I've searched the KR manual for a cable tension number. ??? Any advice or direct knowledge? Dan Prichard Portland Oregon
