I printed a set at Kinkos. I think it cost me about $5.00. I just showed up with a 3.5 Floppy with the PDF on the disk, and said "Print this." After a few iterations, they got it right.
Mark Youkey [email protected] Oklahoma City ----- Original Message ----- From: "Mark Langford" <[email protected]> To: "KR builders and pilots" <[email protected]> Sent: Tuesday, July 15, 2003 7:11 AM Subject: Re: KR>New wing plans > Gavin wrote: > > > I Have been trying to print the plans for the new wing profiles, > which I downloaded from the net in PDF format !!! But I can't make it > happen, Can anybody please tell me how it's to be done so that I can have a > good look at them in full size? < > > You either need a roll-feed plotter that can plot 36" wide stuff 97 inches > long, or you need to find a print shop or architect's office that can do it > for you. > > Mark Langford, Huntsville, AL > N56ML at hiwaay.net > see KR2S project N56ML at http://home.hiwaay.net/~langford > > > > _______________________________________________ > see KRnet list details at http://www.krnet.org/instructions.html
