On the intake does anyone know if it hurts the performance of the engine if you mount the intake tubes from the rear. Instead of welding onto the top, I seen someone's pictures whcih they made the intake go strait back and down.
Justin N116JW www.geocities.com/attngrabber14/Home ----- Original Message ----- From: "Mark Jones" <[email protected]> To: "KR builders and pilots" <[email protected]> Sent: Sunday, September 07, 2003 9:51 AM Subject: Re: KR>New Photos > Justin, > Yes that is the fuel pump. There will be a small hump there on the cowl. For > intakes, check my link: > http://mywebpage.netscape.com/n886mj/intake.html > > Mark Jones (N886MJ) > Wales, WI USA > E-mail me at [email protected] > Visit my KR-2S CorvAIRCRAFT web site at > http://mywebpage.netscape.com/n886mj/homepage.html > > > ----- Original Message ----- > From: "Justin" <[email protected]> > To: "KR builders and pilots" <[email protected]> > Sent: Sunday, September 07, 2003 1:22 PM > Subject: Re: KR>New Photos > > > > Looking good, glad to see a corvair. I have a few questions for you. What > is > > that thing towards the firewall, maybe the fuel pump? > > Steve Makish made his own intake (i think it was him) for the corvair. > > Correct me if im wrong though, I remember looking at some photo's of a > > corviar with home made intake that welding the intake tubes from the > > firewall side of the engine down to the carb on the bottom. I can't seem > to > > find the link though. > > Justin > > N116JW > > www.geocities.com/attngrabber14/Home > > ----- Original Message ----- > > From: "Mark Jones" <[email protected]> > > To: "KR Net" <[email protected]>; "Corvaircraft" <[email protected]> > > Sent: Saturday, September 06, 2003 8:58 PM > > Subject: KR>New Photos > > > > > > I have been working on my cowl and have posted new photos on the "Photo of > > the Week" page. Here is the link: > > http://mywebpage.netscape.com/n886mj/photo.html > > I pulled the cowl from a mold and then cut out the sections which did not > > fit my set up. My firewall is a little wider than the stock firewall. > After > > I cut out the sections, I then filled with foam and sanded to shape. The > > photos tell the story. > > > > Hoping to make Red Oak....it's questionable right now. > > > > Mark Jones (N886MJ) > > Wales, WI USA > > E-mail me at [email protected] > > Visit my KR-2S CorvAIRCRAFT web site at > > http://mywebpage.netscape.com/n886mj/homepage.html > > > > _______________________________________________ > > see KRnet list details at http://www.krnet.org/instructions.html > > > > > > > > _______________________________________________ > > see KRnet list details at http://www.krnet.org/instructions.html > > > > _______________________________________________ > see KRnet list details at http://www.krnet.org/instructions.html >
