Hello Netheads, Take a look at my web site you may see a quadrant there ;). AC
[email protected] wrote: > > Adding a mixture lever is very easy. All you have to do is to "pile up" > two throttle units, which means you will add a third plate on top of the > second plate. You'll have to make the second handle (mixture) the same way, > but > smaller, and bent suitably for clearance. > You'll then use a longer friction screw, which will adjust friction for > both levers at the same time. > It will work fine if you make your spacers accurately. > ------------------------------- > I built mine pretty much this same way with Throttle, Carburetor Heat and > Trim wheel into the left arm rest on one shaft with a tension knob. > Additional > levers and friction disc are very easy to add. Serge, yours sure is a > beauty. > Lynn Hyder N37LH > _______________________________________ > to UNsubscribe from KRnet, send a message to [email protected] > please see other KRnet info at http://www.krnet.org/info.html > -- Adrian VE6AFY Mailto:[email protected] http://www.cuug.ab.ca/~cartera
