Hi guys
I was busy this afternoon marking out a spar on one of the ply skins for the
outer rear spars when I realised that I had made a mistake and proceeded to
rub out the line with a normal pencil rubber. because the pencil line was
drawn 90deg to the grain of the ply so I had to rub up and down with the
grain while slowly following the line covering quite a wide area in the
process.My question is this: What is the effect of this on the epoxy to ply
joint in areas where the rubber has covered, if any?
Any comments?
Dene Collett
KR2S-RT builder
Port Elizabeth
South Africa
mailto: [email protected]
P.S: checkout www.whisperaircraft.com
