I checked the KR2S plans again, and measured with dividers, ( from the
plan view ), the difference in width between the upper and lower longerons
at the front of the rudder post, and the top is wider than the bottom by
about 30 percent. Yet in the assembly manual there is a "perspective" view
which seems to show no difference in width, the KR2 plans, again from the
plan view show no difference in width???? Confusing!
Chris Johnston
RICHMOND AUSTRALIA
----- Original Message -----
From: "VIRGIL N SALISBURY" <[email protected]>
To: <[email protected]>
Sent: Monday, March 27, 2006 2:23 PM
Subject: Re: KR> ruder post
> the rudder post on the K R 1 was tilted back 7 Degrees. Taper
> front to back
> of the post was to meet the aft Fus when sprung in. From above the Fus,
> the only
> taper was from the top of the Fus to the tip. Check the top view of the
> plans again, Virg
>
> On Mon, 27 Mar 2006 13:06:50 +1000 "Chris Johnston"
> <[email protected]> writes:
>> I need some advice on the kr2s rudder post, it looks as though
>> from the plans the the section of the rudder post buried in the aft
>> fuselage must be tapered, as the top longerons are wider than the
>> bottom longerons, but this section must also be bevelled, how far up
>> do you run the bevel? it looks as though on the kr2, that there is
>> no taper on the lower part of the rudder post? I have searched the
>> archives and not found anything useful and have found no
>> construction photos either of anything usefull, but I may have just
>> been looking in all the wrong places.
>>
>>
>>
>>
>>
>> Chris Johnston
>>
>>
>>
>>
>> Richmond
>> Australia
>> _______________________________________
>> Search the KRnet Archives at
>> http://www.maddyhome.com/krsrch/index.jsp
>> to UNsubscribe from KRnet, send a message to [email protected]
>> please see other KRnet info at http://www.krnet.org/info.html
>>
>>
>
>
> Virgil N. Salisbury - AMSOIL
> www.lubedealer.com/salisbury
> Miami ,Fl
>
> _______________________________________
> Search the KRnet Archives at http://www.maddyhome.com/krsrch/index.jsp
> to UNsubscribe from KRnet, send a message to [email protected]
> please see other KRnet info at http://www.krnet.org/info.html
>
