If you can't build of the KRnet you better just forget it. [email protected]
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Dejan Ninkovic Sent: Saturday, May 15, 2010 9:57 PM To: KRnet Subject: Re: KR> apology Don't worry about it. I find most of the info in krnet very interesting to read. Still not able to start building. Best regard Denny On Sat, May 15, 2010 at 5:45 PM, <[email protected]> wrote: > My apology to you. > I inadvertently sent a message to you about 7:00 PM that should have been > addressed to Daniel Heath who is a KRnet member at < [email protected]_ > (mailto:[email protected]) >. I have since sent a reply to Daniel's > inquiry. > You can ignore my email to you but it was as follows just in case you were > thinking of forwarding the reply and to wondering to whom. It is the one > that read as follows: > > Daniel Heath, > Sounds like an instrument hookup perhaps? > > Parker Hannifin and Swagelox have a lot of fittings. > A possible solution may be an elbow that has a male 1/4 inch flare fitting > on one end and then flare a short 1/4 inch tube, attach with ferrule and a > "B" nut and then slide a 1/4 inch inside diameter hose over the tube. > An aircraft instrument shop may have what you need. > I am guessing at your application but perhaps this may be of some help. > I did read your recommendations on replies directly to the inquirer and > I messed up and apologize. Will be a bit more careful in the future. > Aaron Martin > > _______________________________________ > Search the KRnet Archives at http://www.maddyhome.com/krsrch/index.jsp > to UNsubscribe from KRnet, send a message to [email protected] > please see other KRnet info at http://www.krnet.org/info.html > _______________________________________ Search the KRnet Archives at http://www.maddyhome.com/krsrch/index.jsp to UNsubscribe from KRnet, send a message to [email protected] please see other KRnet info at http://www.krnet.org/info.html
