All lumber surfaces exposed to air need to be sealed, including bolt holes
and the cavities inside the spars.
You can use the same type epoxy that was used to build the wooden parts.
After mixing the two A and B parts, thin with a small amount of Acetone and
paint the mixture on with a disposable brush. The Acetone will not affect
the epoxy, but will evaporate as the epoxy cures. If you need to to glue
another piece to the finished work, just scuff sand the wax off and ready to
go again. Do use Acetone with lots of fresh air.
Sid Wood
Tri-gear KR-2 N6242
California, MD, USA
-----------------------------------------------------------------
Is 2 part varnish needed for kr spars and boat or is spar varnish ok
Thanks
_______________________________________________
Search the KRnet Archives at https://www.mail-archive.com/[email protected]/.
Please see LIST RULES and KRnet info at http://www.krnet.org/info.html.
see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to change
options.
To UNsubscribe from KRnet, send a message to [email protected]
