All that is very true. But I have never been happy with the way I made my cowl, 
and didn’t like the look. So waiting on push rods from the USA to fix my tappet 
clearances, so modifying my cowl


 This is the cut out line. I raised the cowl by two inches. That’s how fate the 
cowl protruded parts the bottom of F/Wall. (Not good) 

Next is the fitting now without the air intake cut out 



Sent from my iPhone

> On 13 Aug 2026, at 09:01, Larry Flesner via KRnet <[email protected]> 
> wrote:
> 
> 
>> On 8/12/2026 8:59 AM, Larry Flesner via KRnet wrote:
>> I’m modifying my cowl for better streamlining. But my 0200 has the C150 type 
>> air intake and carb heat. Its problem is it’s about 3” lower than the sump.
>> So does anyone have a good drawing or photo os a lower profile air cleaner 
>> intake with carb heat please
>> Thanks
>> Phil matheson
> 
> ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
> 
> 
> This recent discussion on cowls and streamlining caused the synapses in my 
> "too much idle time in my retired brain" to involuntarily start to process 
> numbers.   As builders / pilots we often go looking for one or two more MPH 
> in speed just to see a higher reading ASI, just to prove we can do it, or to 
> fantasize on beating our flying buddies to the destination of the $100 
> hamburger location.
> 
> Before you start chasing numbers consider what it will cost in time and money 
> to gain 5 mph in a 150 mph airplane.  Lets assume your normal flights are 
> within 150 miles and ,except on X-country trips, less than 150 miles, a 
> casual flight around the area.  So, lets say you will make a Saturday morning 
> breakfast flight to an airport 150 miles distant.  At 150 mph cruise it will 
> take 60 minutes.  You then spend $500 and 20 hours labor and now your KR 
> bullet will make 155 mph cruise.  You just saved 1minute and 48 seconds on 
> that Saturday morning breakfast run.  Oh, but you say, you'll save another 1 
> minute and 48 seconds on the flight home. 🙂 I could probably gain more time 
> than that with a smart cruise / climb and a smart letdown at the destination.
> 
> Before you make an modifications to your airplane, consider the cost / gain 
> numbers and see if you'd rather spend that $500 on fuel and the 20 hours out 
> chasing thermals.
> 
> Larry Flesner
> 
> 
> --
> KRnet mailing list
> [email protected]
> https://list.krnet.org/mailman/listinfo/krnet
-- 
KRnet mailing list
[email protected]
https://list.krnet.org/mailman/listinfo/krnet

Reply via email to