Nice patchset. Some comments on the emulation part:
+#define OP_31_XOP_EIOIO 854
You mean EIEIO.
+ case 19:
+ switch (get_xop(inst)) {
+ case OP_19_XOP_RFID:
+ case OP_19_XOP_RFI:
+ vcpu->arch.pc = vcpu->arch.srr0;
+ kvmppc_set_msr(vcpu, vcpu->arch.srr1);
+ *advance = 0;
+ break;
I think you should only emulate the insns that exist on whatever the
guest
pretends to be. RFID exist only on 64-bit implementations. Same
comment
everywhere else.
+ case OP_31_XOP_EIOIO:
+ break;
Have you always executed an eieio or sync when you get here, or
do you just not allow direct access to I/O devices? Other context
synchronising insns are not enough, they do not broadcast on the
bus.
+ case OP_31_XOP_DCBZ:
+ {
+ ulong rb = vcpu->arch.gpr[get_rb(inst)];
+ ulong ra = 0;
+ ulong addr;
+ u32 zeros[8] = { 0, 0, 0, 0, 0, 0, 0, 0 };
+
+ if (get_ra(inst))
+ ra = vcpu->arch.gpr[get_ra(inst)];
+
+ addr = (ra + rb) & ~31ULL;
+ if (!(vcpu->arch.msr & MSR_SF))
+ addr &= 0xffffffff;
+
+ if (kvmppc_st(vcpu, addr, 32, zeros)) {
DCBZ zeroes out a cache line, not 32 bytes; except on 970, where there
are HID bits to make it work on 32 bytes only, and an extra DCBZL insn
that always clears a full cache line (128 bytes).
+ switch (sprn) {
+ case SPRN_IBAT0U ... SPRN_IBAT3L:
+ bat = &vcpu_book3s->ibat[(sprn - SPRN_IBAT0U) / 2];
+ break;
+ case SPRN_IBAT4U ... SPRN_IBAT7L:
+ bat = &vcpu_book3s->ibat[(sprn - SPRN_IBAT4U) / 2];
+ break;
+ case SPRN_DBAT0U ... SPRN_DBAT3L:
+ bat = &vcpu_book3s->dbat[(sprn - SPRN_DBAT0U) / 2];
+ break;
+ case SPRN_DBAT4U ... SPRN_DBAT7L:
+ bat = &vcpu_book3s->dbat[(sprn - SPRN_DBAT4U) / 2];
+ break;
Do xBAT4..7 have the same SPR numbers on all CPUs? They are CPU-
specific
SPRs, after all. Some CPUs have only six, some only four, some none,
btw.
+ case SPRN_HID0:
+ to_book3s(vcpu)->hid[0] = vcpu->arch.gpr[rs];
+ break;
+ case SPRN_HID1:
+ to_book3s(vcpu)->hid[1] = vcpu->arch.gpr[rs];
+ break;
+ case SPRN_HID2:
+ to_book3s(vcpu)->hid[2] = vcpu->arch.gpr[rs];
+ break;
+ case SPRN_HID4:
+ to_book3s(vcpu)->hid[4] = vcpu->arch.gpr[rs];
+ break;
+ case SPRN_HID5:
+ to_book3s(vcpu)->hid[5] = vcpu->arch.gpr[rs];
HIDs are different per CPU; and worse, different CPUs have different
registers (SPR #s) for the same register name!
+ /* guest HID5 set can change is_dcbz32 */
+ if (vcpu->arch.mmu.is_dcbz32(vcpu) &&
+ (mfmsr() & MSR_HV))
+ vcpu->arch.hflags |= BOOK3S_HFLAG_DCBZ32;
+ break;
Wait, does this mean you allow other HID writes when MSR[HV] isn't
set? All HIDs (and many other SPRs) cannot be read or written in
supervisor mode.
Segher
--
To unsubscribe from this list: send the line "unsubscribe kvm" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
