On 04/05/2010 12:04 PM, Dan Johansson wrote:
> Must I specify an IP for the br-eth3 interface?
You do not have to specify an IP address for the bridge.
In my case:
mainbr0 Link encap:Ethernet HWaddr <mac>
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:7328933 errors:0 dropped:0 overruns:0 frame:0
TX packets:6992 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:481076877 (458.7 MiB) TX bytes:629184 (614.4 KiB)
tap0 Link encap:Ethernet HWaddr <mac>
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:139390 errors:0 dropped:0 overruns:0 frame:0
TX packets:7460821 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:500
RX bytes:13554808 (12.9 MiB) TX bytes:601113602 (573.2 MiB)
# brctl show
bridge name bridge id STP enabled interfaces
mainbr0 8000.<mac> no tap0
eth0
eth0 is the interface connected to the physical LAN. mainbr0 ties the
VM's tap to eth0.
David
>
> Regards,
--
To unsubscribe from this list: send the line "unsubscribe kvm" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
