On Fri, 2012-08-03 at 12:51 +0200, Jan Kiszka wrote:
> From: Jan Kiszka <[email protected]>
>
> Drop pci_map_irq/piix_get_irq in favor of upstream's new interface. This
> should also properly model disabling of the line at PCI host controller
> level.
>
> Signed-off-by: Jan Kiszka <[email protected]>
> ---
> hw/device-assignment.c | 29 +++++++++++++++++++----------
> hw/pc.h | 4 ----
> hw/pci.c | 4 ----
> hw/pci.h | 2 --
> hw/piix_pci.c | 7 -------
> 5 files changed, 19 insertions(+), 27 deletions(-)
>
> diff --git a/hw/device-assignment.c b/hw/device-assignment.c
> index cc39958..d14c327 100644
> --- a/hw/device-assignment.c
> +++ b/hw/device-assignment.c
> @@ -115,7 +115,7 @@ typedef struct AssignedDevice {
> AssignedDevRegion v_addrs[PCI_NUM_REGIONS - 1];
> PCIDevRegions real_device;
> int run;
> - int girq;
> + PCIINTxRoute intx_route;
> uint16_t h_segnr;
> uint8_t h_busnr;
> uint8_t h_devfn;
> @@ -865,21 +865,24 @@ static int assign_device(AssignedDevice *dev)
> static int assign_irq(AssignedDevice *dev)
> {
> struct kvm_assigned_irq assigned_irq_data;
> - int irq, r = 0;
> + PCIINTxRoute intx_route;
> + int r = 0;
>
> /* Interrupt PIN 0 means don't use INTx */
> if (assigned_dev_pci_read_byte(&dev->dev, PCI_INTERRUPT_PIN) == 0)
> return 0;
>
> - irq = pci_map_irq(&dev->dev, dev->intpin);
> - irq = piix_get_irq(irq);
> + intx_route = pci_device_route_intx_to_irq(&dev->dev, 0);
> + assert(intx_route.mode != PCI_INTX_INVERTED);
>
> - if (dev->girq == irq)
> + if (dev->intx_route.mode == intx_route.mode &&
> + dev->intx_route.irq == intx_route.irq) {
> return r;
> + }
>
> memset(&assigned_irq_data, 0, sizeof(assigned_irq_data));
> assigned_irq_data.assigned_dev_id = calc_assigned_dev_id(dev);
> - assigned_irq_data.guest_irq = irq;
> + assigned_irq_data.guest_irq = intx_route.irq;
> if (dev->irq_requested_type) {
> assigned_irq_data.flags = dev->irq_requested_type;
> r = kvm_deassign_irq(kvm_state, &assigned_irq_data);
> @@ -889,6 +892,11 @@ static int assign_irq(AssignedDevice *dev)
> dev->irq_requested_type = 0;
> }
>
> + if (intx_route.mode == PCI_INTX_DISABLED) {
> + dev->intx_route = intx_route;
> + return 0;
> + }
> +
> retry:
> assigned_irq_data.flags = KVM_DEV_IRQ_GUEST_INTX;
> if (dev->features & ASSIGNED_DEVICE_PREFER_MSI_MASK &&
> @@ -917,7 +925,7 @@ retry:
> return r;
> }
>
> - dev->girq = irq;
> + dev->intx_route = intx_route;
> dev->irq_requested_type = assigned_irq_data.flags;
> return r;
> }
> @@ -1029,7 +1037,7 @@ static void assigned_dev_update_msi(PCIDevice *pci_dev)
> perror("assigned_dev_enable_msi: assign irq");
> }
>
> - assigned_dev->girq = -1;
> + assigned_dev->intx_route.mode = PCI_INTX_DISABLED;
> assigned_dev->irq_requested_type = assigned_irq_data.flags;
> } else {
> assign_irq(assigned_dev);
> @@ -1160,7 +1168,7 @@ static void assigned_dev_update_msix(PCIDevice *pci_dev)
> return;
> }
> }
> - assigned_dev->girq = -1;
> + assigned_dev->intx_route.mode = PCI_INTX_DISABLED;
Should both of these set assigned_dev->intx_route.irq = -1 as well? I
don't think it hurts anything this way but we test both mode & irq in
assign_irq() and we'll end up calling kvm_deassign_irq() again.
> assigned_dev->irq_requested_type = assigned_irq_data.flags;
> } else {
> assign_irq(assigned_dev);
> @@ -1784,7 +1792,8 @@ static int assigned_initfn(struct PCIDevice *pci_dev)
> e_intx = dev->dev.config[0x3d] - 1;
> dev->intpin = e_intx;
> dev->run = 0;
> - dev->girq = -1;
> + dev->intx_route.mode = PCI_INTX_DISABLED;
> + dev->intx_route.irq = -1;
And here we set both, so it's a little inconsistent.
> dev->h_segnr = dev->host.domain;
> dev->h_busnr = dev->host.bus;
> dev->h_devfn = PCI_DEVFN(dev->host.slot, dev->host.function);
> diff --git a/hw/pc.h b/hw/pc.h
> index a662090..5b36eb5 100644
> --- a/hw/pc.h
> +++ b/hw/pc.h
> @@ -171,10 +171,6 @@ PCIBus *i440fx_init(PCII440FXState **pi440fx_state, int
> *piix_devfn,
> extern PCIDevice *piix4_dev;
> int piix4_init(PCIBus *bus, ISABus **isa_bus, int devfn);
>
> -int piix_get_irq(int pin);
> -
> -int ipf_map_irq(PCIDevice *pci_dev, int irq_num);
> -
> /* vga.c */
> enum vga_retrace_method {
> VGA_RETRACE_DUMB,
> diff --git a/hw/pci.c b/hw/pci.c
> index 5ef3453..0b22913 100644
> --- a/hw/pci.c
> +++ b/hw/pci.c
> @@ -1089,10 +1089,6 @@ static void pci_set_irq(void *opaque, int irq_num, int
> level)
> pci_change_irq_level(pci_dev, irq_num, change);
> }
>
> -int pci_map_irq(PCIDevice *pci_dev, int pin)
> -{
> - return pci_dev->bus->map_irq(pci_dev, pin);
> -}
> /* Special hooks used by device assignment */
> void pci_bus_set_route_irq_fn(PCIBus *bus, pci_route_irq_fn
> route_intx_to_irq)
> {
> diff --git a/hw/pci.h b/hw/pci.h
> index c69af01..4b6ab3d 100644
> --- a/hw/pci.h
> +++ b/hw/pci.h
> @@ -274,8 +274,6 @@ void pci_register_bar(PCIDevice *pci_dev, int region_num,
> uint8_t attr, MemoryRegion *memory);
> pcibus_t pci_get_bar_addr(PCIDevice *pci_dev, int region_num);
>
> -int pci_map_irq(PCIDevice *pci_dev, int pin);
> -
> int pci_add_capability(PCIDevice *pdev, uint8_t cap_id,
> uint8_t offset, uint8_t size);
>
> diff --git a/hw/piix_pci.c b/hw/piix_pci.c
> index a5090cb..355814f 100644
> --- a/hw/piix_pci.c
> +++ b/hw/piix_pci.c
> @@ -435,13 +435,6 @@ static void piix3_write_config(PCIDevice *dev,
> }
> }
>
> -int piix_get_irq(int pin)
> -{
> - if (piix3_dev)
> - return piix3_dev->dev.config[0x60+pin];
> - return 0;
> -}
> -
> static void piix3_write_config_xen(PCIDevice *dev,
> uint32_t address, uint32_t val, int len)
> {
--
To unsubscribe from this list: send the line "unsubscribe kvm" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
