Thanks for the reply Phil. I've tried that (and re-tried just to be sure) but still no success. I get a message stating:
NO PBX ANSWER - check hardware and com-port parameters Bill Rakowitz -----Original Message----- From: [EMAIL PROTECTED] [mailto:kxt-admin@;kxthelp.com] On Behalf Of Phil Barrett Sent: Tuesday, October 29, 2002 12:40 PM To: [EMAIL PROTECTED]; 'Panasonic Help' Subject: Re: KX-T: Terminal server -> KXTD I've used the Comtrol TS. I had a similar problem with Programmator - it turned out that the default Comm Settings used Mark. I changed it to N (i.e. 9600 8 N 1) and it worked. You might try that. At 10:38 PM 10/28/2002 -0600, Bill Rakowitz wrote: >Has anyone connected an Equinox MDS-10 (one port serial to Ethernet >terminal server) to a KXTD 1232? > >I can see SMDR data thru my LAN but I can not connect using the >programming software. I think I'm dealing with configuration issues of >the MDS-10 since I can direct connect a laptop to the KXT and connect >through the programming software. > >TIA, > >Bill Rakowitz > > > >_________________________________________________________________ >KX-T Mailing list --- http://kxthelp.com/ >Subscription changes: http://kxthelp.com/mailman/listinfo/kxt > > _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
