Hello, I have a TD612 ere and I have some questions about the Device what one of you might can answer.
I have added all the telephonenumbers to SPD & CH number that we have here, it are four numbers for a point-to-multipoint line. At this moment the other numbers that are attached to a different system don't ring anymore on this device, very nice because that was annoying. After this I have added to [623] the number of the 4 numbers that I want to use to sent out and receive on my system. After this the following Programmings are done following the Quickstart-manual: [423] [424] [425] [426] I have restarted the system but when I call my number that is not attahced to the other system it gives an "busy" tone and the phones are not ringing. I have done the configuration using the T7533 telephone. When I call to outside the number that is displayed on the receiving screen is the ISDN-basenumber and not what I have configured in the Programmings that I have displayes above. Something else is when I conect using the ProgrammingSoftware I get a message that the Firmware of the system is too old and I need an upgrade. I have the latest Firmware but can't find anywhere how to Flash the TD612 and which software I have to for this. The last question is how I can use the whole version of the Programming-software and nog the restricted version. Or does this have to do something with the old-firmware-version that I run on the system and the newer Programmingsoftware........ not compatible ? I hope you all can help me to solve these "problems". Thank you. _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
