If at default- any ringing co rings all stations, if stations are used as co's you get a loop ring co1, all stas ring causing all connected cos to ring.
-larry [EMAIL PROTECTED] wrote: >I should probable know this . I pulled a couple of old KX-TD1232's off the >shelf to check them out >(Version P211D00712A). I hooked up a couple analog ports to be co lines. >When I dialed one of the extensions both would ring no matter which co's I >used. I could get on one line & dial the other & it would work fine. When I >unhooked the co's the analog lines would ring separably. Any suggestions. >Both cabinets did the same thing. > >Thanks > >Ken > > > > >**************************************See AOL's top rated recipes >(http://food.aol.com/top-rated-recipes?NCID=aoltop00030000000004) >_________________________________________________________________ >KX-T Mailing list --- http://kxthelp.com/ >Subscription changes: http://kxthelp.com/mailman/listinfo/kxt > > > _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
