Hi Lorri,

Don't sew -- pin.  Get a bunch of sewing pins, shorter
is better.  Cut a rectangle of fabric, wide enough to
go across the block and 2/3 down each side.  Cut it
long enough to wrap around the block with 1/2" extra.

Get some felt and cut squares the same size as your
blocks.  Pin to the top and bottom of each block with
a pin near each corner.

Start in the middle of one side, center the fabric and
pin each side near the edge of the block.  Wrap
snuggly around the block, fold under 1/4 inch and pin
the overlapping fold with several pins. I use 5-6 pins
with a 5 inch block.

Continue, making sure the fabric is pulled snug at
each step.

On one side, fold down the narrow ends and pin each
end near each edge.  This will make the fabric on the
long sides have a slanted fold.  Fold down one long
side and pin each end.  Fold the other side down, tuck
under 1/4 inch and pin with 3-4 pins.  Add another pin
on each end where the slanted folds meet.  If any fold
pokes up, add a pin.  Do the same with the other side.

There...with 5 minutes work you have a block that will
last as long as the foam in it holds up.  (And you
didn't do a bit of sewing.)  If you do spill
coffee/wine/chocolate on it, you can unpin the fabric
and wash or replace it easily.  Otherwise, it will
stay together.

I just used the pin method to cover all the blocks and
roller of a One and Only pillow.  I even used pins for
most of the main pillow cover.  Since I have a ton of
small brass pins that I don't like to use, I used them

on this pillow.  True...I bent a few, but I wasn't
worried about it.

By the way, I will disagree with my friend LeAnn on
the size of her block pillow.  LeAnn, if your blocks
fit the One and Only, they are 5" blocks, and your
pillow is only 15" wide.  That *is* a bit small for
comfortable working, but packs well in a suitcase.  I
would suggest 6" pillows for a block pillow.  If it's
for a larger project, make it a 12 block pillow
instead of the standard nine block.  Either larger
blocks or more blocks would give more working surface.

Someone on this list, recently, held pillow blocks
together with a sturdy elastic band.

The precut blocks are quite inexpensive.  A non-sewing
block pillow is a possible project on a low budget. 
Cardboard and tape can make a base.  Go for it -- you
can do it.

My wish to visit England again is a more expensive
propsition.  But I can always dream.......

Alice in Oregon


--- Lorri Ferguson <[EMAIL PROTECTED]> wrote:

>   3)I guess if I had to pick one thing,  I would say
> a block   pillow.  I have seen some in catalogs, but
they are expensive.  I have
>   seen some at a Lace Day, not so expensive, but the
> blocks weren't  covered, and that was a problem.  I
am useless at sewing and could not
>   even figure out how I would go about covering
> blocks.  

-
To unsubscribe send email to [EMAIL PROTECTED] containing the line:
unsubscribe lace [EMAIL PROTECTED] For help, write to
[EMAIL PROTECTED]

Reply via email to